Topic: What are your thoughts on this exhaust tip?

[bluedevil]

Im looking at doing something quite unique.

What are your thoughts of this exhaust tip setup?

This C6 exaust tip underneath the Lic plate




Link


or.....these.....

both sides the Lic plate


Link

[oHIobellboy]

I like the top one better, however, I'm not too sure how it would look "hanging" under the LP. Maybe move the LP a little higher and put the exhaust under it then so it also comes out of the RP? I know, spinning the gears again and making everyone think.

[MyBigToy]

I like the C6 but don't bring it out underneath the license plate. Relocate the license plate and bring it out in the center of the cut-out. Or, put the license plate on one of the motorized holders that folds up underneath.

You could always do option #2 and bring them through the cladding on the sides. Powersurge on CAFCNA did that many moons ago.

[Fowlhunter]

What about option 2 through the roll pan?  One on each side?

[Richie_Rich]

Of the two, I'd go with option #1.

I don't like the idea of rigidly mounting my exhaust to a body panel.
The heat and vibration along with flexing from engine movement, etc tends to put stress on things.

[Main One]

I'd do option 2.

[MightyMouse]

I like #1. I'd either relocate the LP, or (my preferred option) split the tips, spread them out, and bring them out throught the roll pan 

[boilers94]

#1!! 

[tdybr27]

after reading all the #1 and #2, I have to go to the bathroom now     

[Richie_Rich]

after reading all the #1 and #2, I have to go to the bathroom now     

Remember to wash your hands 

[The Beast]

I vote for #1...looks like the SLP tip.

[Strobin]

1 would be cool but not just thrown on there, it would stick out like a sore thumb.  Would need a rear valance like this around the exhaust


or option that I've thought your AV has needed since doing the rollpan to just dump the exhaust so no pipe or tip is showing.