Did you know?A 'Vortec' 8.1L V8 produces 340 hp (253 kW), for the three-quarter-ton 2500 series.
0 Members and 2 Guests are viewing this topic.
If I am hooking into the trailer harness, would I connect all 8 leds together, then make ONE connection into the harness, (as opposed to TWO connections, one for each tail light)?
Don't know anything about the picture you have seen other than what you said, but if one were to use say 2 160 ohm resistors wired in series that would be equivalent to a single 320 ohm resistor, as far as the resistance goes. Alternatively you could use 2 640 ohm resistors wired in parallel to equal a single 320 ohm resistor.The 2 160 or 640 ohm resistors could each be rated at half the power as the single 320 and together could handle the power that the 320 would be rated at.
I'm confused too. I count two resistors in each pic. Don't know where you come up with 4.
A little confusion here....I plan on hooking up into the brake lights, turn signal, etc. I have wired the resistors and diodes based on the 1st drawing. 1st picture was from this article:http://www.chevyavalancheclub.com/index.php?action=articles;sa=view;article=332nd picture is my wiring based on that article/1st picture. One setup for each side L/R.Now, I have also seen this picture that has TWO resistors instead of one?? So...I'm a little confused????
.... The only thing I'd suggest, and just my opinion, is to do the all 4 brake light mod while you have everything opened up.